Dette handler godt nok om linkiys router men du kan måske få noget ud af det,
hvem hved?jeg hhhhhvender tilbage,hvis du har fremskridt så oplys.
Corrupted firmware Fix.
When upgrading the router should always ensure yourself from the pain of the DIAG light flash of death by following these instructions,, (also follow these instructions if you have the light flashing)
----------------------------------------------------------
REFLASHING THE ROUTER WHEN THE DIAG LIGHT IS BLINKING
The blinking diag light usually means that the firmware is corrupted or incomplete.
Fortunately, this is recoverable by following the procedure below.
1) Remove all connected computers from the router except for one computer (preferably,
your best computer).
2) Reset the router by holding down the reset button for at least 10 seconds.
3) Go to control panel, double click on network, then double click on TCP/IP -> for
your network card. Go to IP ADDRESS, and specify it using the following:
ip = 192.168.1.2 subnet = 255.255.255.0
Click OK.
4) Next, if you have a 10/100 network card, double click on your network card adapter
under network configuration. Click on the ADVANCED TAB, and you should see a
properties option for "media type" or "connection type" or "mode" that currently
has its value set to "auto sense" or "auto". If you click on the arrow button
next to value you'll see other selectable modes. Change the value and select the
lowest mode, which may be something like "10T half" or "10 hd" or just "10" etc.
the lowest value is 10baseT half duplex. Click ok after you made the change.
5) Click OK again. Your computer may start copying files and ask for a windows cd. Give
the computer whatever it asks for. It will then ask you to reboot the computer.
Say "yes" to a reboot.
6) When the system is completely back at the desktop, click on Start, Run, then type in
"command". This will open an MS-DOS prompt. At the prompt, type in
"ping 192.168.1.1" If you get a "Reply from...", then exit out of the MS-DOS
prompt, and start the flash upgrade. If you get a "Request time out" or
"Destination host unreachable" then go to step 7b.
7a) When the flash is completed, go back to IP ADDRESS as described in step 3, and change
your ip address back to "obtain an ip address automatically" or whatever settings
you had originally working with the router.
7b) Connect the computer directly to your broadband modem using the same network card and
cables you've been using in this procedure. Set the computer up for internet access
according to your internet service provider's required configuration settings. If
you gain internet access, then call Linksys for a possible RMA or further instructions.
If you DO NOT gain internet access, then call your ISP or network card manufacturer.
Det er ikke dit net kort der er noget i vejen med når du ikke har problemer
med at komme på uden router men det kan være det's indstilling under avanseret
Manse9933