> Hva' dælen gør man, når man har genopfyldt den tomme
> patron i en HP 930c printer og printeren bliver ved med
> at advare om tom patron.
>
> Jeg har prøvet at slukke og tænde, hive strømmen helt fra
> og fjerne og isætte patronen mange gange, uden held ;o(
>
> Er der en form for "serienummer" på patronen som printeren
> kan huske eller hva' ???
Hej igen, lige en sidste post omkring mit lille problem...
Nu er det løst, det viste sig at der er en form for check af
patronerne, så man kan ikke bare sætte den gamle i igen...
Her er hvad jeg fandt på comp.periphs.printers:
-----
Yes this is normal as the printer doesn't realise you've changed the
cartridge unless it's a brand new cartridge. The printer looks for the
different signature of a new cartridge, probably derived from a simple
binary code via various contacts being on or off inside the cartridge (I'm
guessing here). Some kind person posted a cure for this problem that can
reset either or both cartridges, I'm posting the version for both, just
adapt it for one cartridge if that's all you've refilled:-
Leading the printer to believer the cartridges are new:
Status: refilled cartridges in the printer.
- Turn on the printer.
- Open up the cover, remove both cartridges.
- Place both cartridges in front of you so that you can see the contact
foil, with the nozzles facing downwards.
- With adhesive tape, cover the four upper contact points on the far
left contact column of both cartridges
- something like this:
X . .
X . .
X . .
X . .
.. .
.. .
.. .
.. .
.. .
.. .
.. .
.. .
- Reinsert the two cartridges.
- Close the cover.
- Open the cover again after 2 or 3 seconds.
- Wait until the printer gives you the cartridge carriage (If there
seems to be a problem with either of the cartridges, ignore it)
- Open the cover, remove the two cartridges.
- Place both cartridges infront of you so that you can see the contact
foil, with the nozzles facing downwards.
- Remove the adhesive tape.
- With adhesive tape, cover the four upper contact points on the far
right contact column of both cartridges
- something like this:
.. . X
.. . X
.. . X
.. . X
.. .
.. .
.. .
.. .
.. .
.. .
.. .
- Reinsert the two cartridges.
- Close the cover.
- Open the cover again after 2 or 3 seconds.
- Wait until the printer gives you the cartridge carriage movement (If there
seems to be a problem with either of the cartridges, ignore it)
- Open the cover, remove the two cartridges.
- Remove the adhesive tape.
- Clean the contacts well.
- Reinsert the two cartridges.
- Close the cover.
- That's it !!!
-----
Det virkede for mig
Tak til alle der prøvede at hjælpe...
--
med venlig hilsen - best regards
Michael Sørensen - aka Dino_DK
www.m-k-s.dk - post@REMOVEm-k-s.dk
ICQ#: 41174628 - Homo Sapiens v. 2.00